GE Cardiolab II Plus - Accessory Parts List; Required Tools and Supplies

2-4 Cardiolab® II Plus Amplifier Manual 2002938-002E
Equipment Overview
Accessory Parts List
GE Medical Systems - Information Technologies recommends the
following accessory parts be used with the CardioLab II Plus Amplifier:
Required Tools and Supplies
The following is a list of tools needed to service the CardioLab II Plus
amplifier:
 Adjustable wrench with a capacity of 1/2 inch
 Phillips screwdriver
 Physiologic signal simulator with ECG and pressure outputs
 2 mm pin-jack to ECG jumper wires
 Bourn’s potentiometer tool
 Adapter cable to interface pressure simulator to amplifier inputs
 Torx T10 driver
Table 2. Accessory Parts List
Accessory Name Part Number
Abbott Transpac IV Disposable Transducer
with 4 ft. extension Cable*
Abbott #42582-08
Abbott Transpac Reusable Cable* Abbott #42661-04-42
3M Disposable Electrode for ECG
Monitoring*
3M Red Dot #2256
* This accessory is not stocked by GE Medical Systems Information Technologies.