GE Dash 5000

Troubleshooting: No waveform at central station
6-10 Dash 3000/4000/5000 2000966-542D
No waveform at central station
If you do not have a waveform at the central station:
 Ensure the central station software is compatible.
 Check all cables for a good connection.
 Check the configured alarms and manual print locations at the
patient monitor.
 Ensure the care unit name is the same in the patient monitor and in
the central station.
 Ensure the internet protocol (IP) addresses are configured correctly.
For a troubleshooting tree with more information, refer to “Problem: No
waveforms or parameters are displayed at the CIC Pro center” on
page B-5.