GE Dash 5000

Configuration: Procedures
2000966-542D Dash 3000/4000/5000 4-9
Procedures
Listed below are the patient monitor settings that can be configured.
Each procedure is described on the next pages.
From the Main Menu
 “Set print locations” on page 4-10
From Service Mode
 “Set Unit Name” on page 4-11
 “Set Bed Number” on page 4-11
 “Patient-Monitor Type” on page 4-12
 “Admit Menu” on page 4-13
 “Confirm or configure wireless LAN” on page 4-14
From Boot Code
 “Set Defib Sync Voltage and pulse width” on page 4-18
 “Set Line Frequency” on page 4-18
 “Set CIC and QS protocol” on page 4-19
 “Set MUSE system protocol” on page 4-19
 “Transcutaneous Pace Blank Length” on page 4-19
 “Set Country Selection” on page 4-20
 “Set Language” on page 4-20
 “Enable or disable AFIB Identification” on page 4-21
 “Enable or disable IntelliRate” on page 4-21
 “Analog Out Buzz” on page 4-22
Also see “Advanced user procedures” on page 4-23 to
 “Set time and date” on page 4-23
 “Transfer monitor defaults” on page 4-24
After completing all necessary procedures, go to “Functional and
electrical safety checks” on page 8-1.