GE enFlow IV - Page 4

- 4 of 40 -
4400-0024-EN Rev A
Electric Energy
Eect or action in both directions away from reference point
(Open)
70˚C
-30˚C
Temperature Range
Eect or action in both directions towards a reference point
(Close)
DEHP
Not made with
Di(2-ethylhexyl) phthalate
In transport applications it is advised to cushion and insulate
the Warmer from the patient’s skin and apply the Warmer as
loosely as acceptable checking regularly for signs of potential
pressure-related injury
Manufacturer
IP67
Degree of protection provided by enclosure, dust tight,
temporary water immersion
IP31
Degree of protection provided by enclosure, no ingress of
object > 2.5 mm diameter, protected against dripping water
IP68
Degree of protection provided by enclosure, dust tight,
continuous water immersion
Rx ONLY
Caution: U.S. Federal law restricts this device to sale by or on
the order of a physician
Surface may be hot
Consult Instructions for Use
Do not encase the Warmer with any external coverings like:
towels, sheets, blankets or drapes. Covering the Warmer
restricts the natural convection of heat.
xx
System Fault XX Low Battery
Lock or Password Required Unlock
Do Not Throw in Trash
The CE Mark is the manufacturer’s or importer’s mark of
conformity declaring compliance with all applicable directives
(Safety, EMC, Machinery, Medical and others).
C
CM
US
4005716
Intertek is accredited by OSHA as a NRTL, as well as by the
Standards Council of Canada. This mark indicates that the
product has been tested to CAN/CSA-C22.2 No. 60601-
1:2008 Ed 03, AAMI ES60601-1:2005, IEC 60601-1:2005 Ed
03, IEC 60601-1 -6:2010 Ed 3 and IEC 60601-1-8: 2006 Ed 2.
Mute the Audible ‘High Priority Alarm’ For 1 Minute