GE EST iO500 User Manual

Chapter 3: Programming
140 EST iO64 and iO500 Technical Reference Manual
Event: Only the event type (alarm, supervisory, trouble, etc.) is
reported/transmitted, no device or zone information. Note: This setting uses the
CMS event notification settings for reporting events. Make sure your event
notification settings are correct. Refer to "CMS device programming" for more
information.
Line 1 and 2
Dialing:
Cut duration/supervision:
Program line 1 options, and then program line 2 options. When finished
programming each line, choose Save.
Select Tone or Pulse dialing.
Set the cut duration/supervision to Off or 10 to 120 seconds. Specifies the length of
time a phone line trouble is detected before reporting the trouble.
Tone wait seconds Set tone wait to Off or 1 to 30 seconds. Specifies how long the dialer waits to get a
dial tone.
Call disconnect seconds Set call disconnect to Off or 1 to 45 seconds. Specifies the length of time the dialer
seizes the line (to disconnect parallel devices) before attempting to dial out.
Test frequency days Set test frequency to Off or 1 to 45 days. Specifies how often the dialer performs a
test call. Note: The "off" setting is not acceptable for UL/ULC installations. Refer to
"UL 864 programming requirements" for details.
Test time Set the test time to the desired time of day for running the test.
Rings to answer Set rings to answer to Off or 1 to 15 rings. Specifies how many rings before the dialer
answers incoming calls.
Ring type Set ring type to Any or Normal. Specifies the type of ring expected when an incoming
call is received.
Callback Select Enabled or Disabled.
Callback number Enter the callback phone number (up to 20 digits). This specifies the phone number
that is used for call back.
Panel Configuration
Ann. Class
Annunciator
CMS Device
⇩
CMS Device
Dialer
Network
Swngr Shtdn Rp.200<>
⇩
Dialer
Type Single Line>
Account 1
Account 2
⇩
To program the dialer:
1. Access the panel configuration options menu. See "Panel
configuration options."
2. Choose CMS Device.
3. Choose Dialer.
4. Program the dialer using the "Dialer programming options"
table above. For dialer default settings, see "Factory default
settings."
5. When you're finished programming each option, choose Save.
6. Continue programming your system or press Menu to exit menu
mode.
CMS Device
Swngr Shtdn Rp.200<>
Event Notification
Save

GE EST iO500 Specifications

General

Brand	GE
Model	EST iO500
Category	Control Panel
Language	English