GE EST iO64

Chapter 3: Programming
124 EST iO64 and iO500 Technical Reference Manual
Loop class programming
The loop must be programmed based on how the devices are wired
on the loop (Class A or Class B).
Default: Class B
Loop Configuration
Loop Class
Zone
Correlation Groups
⇩
Loop Class
Loop 1 Class A>
Loop 2 Class A>
Save
⇩
To program loop class:
1. Access the loop configuration options menu. See "Loop
configuration options."
2. Choose Loop Class.
3. Select the loop. If you only have one loop, the loop is
automatically selected.
4. Select either Class A or Class B.
5. Choose Save.
6. Continue programming your system or press Menu to exit menu
mode.
Loop Class
Loop 1 Class A>
Loop 2 Class A>
Save