GE EST iO64

Chapter 3: Programming
EST iO64 and iO500 Technical Reference Manual 151
Enter Password
0000
⇩
Advanced Program
Panel Operation
Panel Events
Loop Events
⇩
Panel Events
System Startup
Ground Fault
Battery Charger
⇩
System Startup
Event Notification
⇩
Trouble
Printer Yes<>
Dialer Account 1&2
NET Yes<>
⇩
7. Choose Event Notification.
8. Set the event notification. See the default settings in the table
above.
Printer: Yes or No. Specifies if event information is printed
Dialer:
Acct 1 & 2: Event information is sent to both dialer accounts
Acct 1: Event information is sent to dialer account one
Acct 2: Event information is sent to dialer account two
None: Event information is not sent to the dialer
NET: Yes or No. Specifies if event information is sent to the
connected network
CID: Contact ID event code (000 to 999)
9. When finished, choose Save.
10. Repeat steps 6 to 9 for each panel event.
11. Continue programming your system or press Menu to exit menu
mode.
Trouble
NET Yes
CID 110
Save