The Fraction Collector Frac-920 software is divided into three main menus:
DescriptionMenu
Run Method is used for running methods that are pro-
grammed by the user. The Run Method menu is dis-
played after the self-test. See
Running a method, on
page 35
.
Program Method is used for creating new methods. To
reach the Program Method menu, press
. See Pro-
gramming a method, on page 31
.
Setup and Check is used for setup and checking internal
system parameters, such as Fraction Base and Delay
UV to Frac. For more information, refer to Fraction col-
lector Frac-920 User Manual. To reach the Setup and
Check menu, press again.
Changing a parameter value
DescriptionNo.
Parameter1
Frac-920 and Frac-950 Operating Instructions 28-9622-09 AC 29
4 Operation
4.1 Fraction Collector Frac-920 stand alone
To Next Page
Loading...
