5 Maintenance
5.1 General
Fraction Collector Frac-920 and Frac-950 require no periodic maintenance.
5.2 Cleaning
WARNING
When using hazardous chemical and biological agents, take all
suitable protective measures, such as wearing protective glasses
and gloves resistant to the substances used. Follow local and/or
national regulations for safe operation and maintenance of Fraction
Collector Frac-920 and Frac-950.
The fraction collector should be kept clean and spilled liquid should be wiped off before
it dries. Remove dirt from the surface using a cloth and a mild cleaning agent.
The rack holder should be positioned over the centre.
The safety bar should be folded down when the fraction collector is not in use (Fraction
Collector Frac-950 only).
When your ÄKTA system is cleaned, also clean the capillaries and the accumulator in
Fraction Collector Frac-950 with distilled water.
The instrument should be wiped regularly with a damp cloth. Remember to wipe the
DropSync unit photocell as well. Allow the instrument to dry completely before use.
Cleaning before planned
maintenance/service
To ensure the protection and safety of service personnel, all equipment and work areas
must be clean and free of any hazardous contaminants before a Service Engineer starts
maintenance work.
Please complete the checklist in the On Site Service Health and Safety Declaration Form
or the Health and Safety Declaration Form for Product Return or Servicing, depending on
whether the instrument is going to be serviced on site or returned for service, respectively.
Copy the form you need from
Section 7.2 Health and Safety Declaration Form, on page52
or print it from the PDF file available on the User Documentation CD.
Frac-920 and Frac-950 Operating Instructions 28-9622-09 AC 47
5 Maintenance
To Next Page
Loading...
