4 Operation
About this chapter
This chapter provides instructions for the use of Fraction Collector Frac-920 and Frac-950.
4.1 Fraction Collector Frac-920 stand alone
Starting the instrument
1
Connect the power cord to the mains power outlet. The display lights up and the
system immediately performs a self-test.
2
During the self-test, several messages are shown on the display, for example system
name and software version number, and a beep is heard. If an error is detected
during the self-test, an error message is shown.
3
The self-test takes about five seconds. When the start-up is completed, the display
shows the Run Method menu.
Menu display
See Fraction Collector Frac-920 for the layout of the Frac-920 front panel.
•
Press
or to select a specific menu.
•
Press OK to enter a sub menu.
•
Press Esc once to move back one menu level, or repeatedly to return to the main
menu level.
28 Frac-920 and Frac-950 Operating Instructions 28-9622-09 AC
4 Operation
To Next Page
Loading...
