78 7978 79
By using the USB cable, you can transfer the captured
photos and videos to a PC. Follow the steps below to
connect the camera to a PC.
1. Start a computer to which ArcSoft software has been
installed.
2. Make sure both the camera and PC are turned on.
3. Connect one end of the supplied USB cable to the
USB/AV OUT port on your camera.
4. Connect the other end of the cable to an available
USB port on your PC.
5. Disconnect the camera once transfer is complete.
If the USB option is set to [PC]
:
Turn the camera o and disconnect the USB cable.
If the USB option is set to [PC (PTP) ] :
Remove the camera from the system as described
below before turning the camera o and disconnecting
the USB cable.
Window XP Home Edition/XP Professional
Click the [Safely Remove Hardware] icon ( )
in the taskbar and select [Safely remove USB Mass
Storage Device] from the menu displayed.
To Next Page
Loading...
Need help?
General
