82 8382 83
Connecting the camera and printer.
1. Make sure both the camera and printer are turned
on.
2. Connect one end of the supplied USB cable to the
USB port on your camera.
3. Connect the other end of the cable to the USB port
on the printer.
If the camera is not connected to a PictBridge
compatible printer, the following error message
appears on the LCD screen.
The above error message would also
appear if the USB mode were set
incorrectly, in which case you should
disconnect the USB cable, check the USB
mode settings, ensure that the Printer is
turned on, and then try connecting the USB
cable again.
To Next Page
Loading...
