38
Door Assembly
Handle
Striker
Door Glass
Door Frame
Door Cover
The door is available as a complete assembly or
components may be replaced separately. See Door
Exploded View on pag e 37.
Note: The door cover protect (not shown in the
image above) is not a part of the door assembly.
Door Assembly Removal
1. Remove the two T25 Torx door mounting screws.
2. Lift door up slightly to disengage the door
assembly holding screw from the front panel
slot, then pull door assembly forward.
Holding Screw
Front Panel Slot
Door Frame
Location: See Door Frame Location on page 37.
Door Frame Removal
1. Remove the door assembly and set it on a fl at
working surface. (See Door Assembly Removal)
2. Remove the two #2 Phillips screws that hold the
door striker and remove the door striker.
3. Remove the nine #2 Phillips screws that hold the
inner door panel and lift the inner door panel to
remove.
Tub and Structure
To Next Page
Loading...
