Need help?Do you have a question about the GE GTWS8655DMC and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | GTWS8655DMC |
| Appliance Category | Washer |
| Color | White |
| Energy Star Certified | Yes |
| Control Type | Electronic |
| Number of Wash Cycles | 12 |
| Number of Spin Speeds | 5 |
| Spin Speed | 800 RPM |
| Steam Function | Yes |
| Smart Technology | No |
| Water Level Settings | Automatic |
| Voltage | 120 V |
| Frequency | 60 Hz |
| Washer Type | Top Load |
| Dispenser | Detergent, Fabric Softener, Bleach |
| Width | 27 in. |
| Height | 46 in. |
Information is for experienced individuals; repair attempts may cause injury or damage.
Disconnect power before servicing; if power is needed, disconnect immediately after checks.
Ensure grounding wires and components are properly re-fastened after service.
Outlines warranty service, contact info, and the requirement for proof of purchase.
Detailed steps for accessing the rear, removing panels, impeller, brackets, and tub.
Explains sensor status, error handling, testing methods, and water level to Hz conversion.
Guides on checking house outlet voltage and connections to the line filter.
Procedures for testing recirculation and drain pump resistance and voltage.
Testing mode shifter motor resistance and position switch continuity.
Testing thermistor resistance, lid lock motor, and lid switch continuity.
Checking lid lock status and tub light voltage/diode test.
Checking UI logic board voltage and drive motor resistance.
Detailed table of fault codes, descriptions, and recommended repair steps.
To Next Page
