Usingthe clock and timer.
Mal{esure,thedock isset to the
correcttimeof day
The clock must be set for the automatic oven timing
ihnctions to work properly. The time of day cannot be
changed during a timed baldng or selikqeaning cycle,
ToSet the Clock:
,,ess, ,eCLOCKpad
i_Press the HOUR and MIN. pads,
Thetimerisam/nuteaneron/y.
Thetirna doesnotcontroloven
operations.Themaximumsed:ingon
thetirz_ris 11hoursand59minutes.
ToSet the Timer:.
Press the TIMERON/Off pad.
;;_Press the HOURand MIN. pads until the amount of
.......--time you want shows in the display. The timer will
start automatically within a tew seconds of
releasing the pad.
ToReset the Timer:.
If the display is still sho_dng the thne remaining, you
may change it 1)ypressing the HOURand MIN. pads until
the time you want appears in the display.
If the remaining time is notin the display, recall tim
remaining time by pressing tim TIMERON/OFFpad and
then pressing lhe HOURand MIN. pads until the new
time you want sh(m:sin the displ W.
ToCancel the Timer:.
Press the TIMERON/OFFpad once. To cancel the
timer press the TIMERONIOFFpad again and hold
fin 4 seconds.
Endof Cycle Tones
Clear the tones 1)ypressing the pad of the flmction you
are using.
If you would like to remove the signal that beeps eveD_6
seconds, press and hold the CLEAR/OFFpad fi)r 10
se('onds.
To return the signal, press and hold the CLEAR/OFFpad
fin 10 seconds. 21
To Next Page
Loading...
