GEAppliances.com
_v Possible Causes What ToDo
Power cord maybe • Reposition the drawer and power cord. See the
obstructing drawer Storage Drawer Removal instrucdons in the Care and
in the lower back cleaning of your range section.
of the range.
Rear drawer support is • Reposition the drawee See the Storage Drawer
on top of the guide rail. Removalinstructions in the Care and cleaning of your
range section.
The oven temperature is • Mlow the oven to cool to room temperature and
too high to set a self-clean reset the controls.
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
This is the sound of the • This is normal.
metal heating and cooling
duringcleaningbothfunctions,the cooking and
Excessive soil. • Press the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED door
cleanlightg°es°ffcycleWipeuptbee×cesssoilandresetthe
Oven too hot. • Allow the oven to cool below locking temperature.
#logo cycle
i
Oven controls not properly set. • See the Using the self-cleaning ovensection.
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
OOR_ The self-dean cycle has been • Close the oven door.
selected but the door is not
0losed
The oven door is locked • Press the CLEAR/OFF pad. Allow the oven to cool.
because the temperature
inside the oven has not
lockingdroppedbelow thetemperature.
You have a function • Press the CLEAR/OFF pad. Put the oven back into
error code. operation.
If the function code repeats. • Disconnect all power to the range for at least 30
secondsandthenreconnectpowerlfthefunctionerror code repeats, call for service.
29
To Next Page
Loading...
