EasyManua.ls Logo

GE JBS05 - Page 32

GE JBS05
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before you call for service...
Troubleshooting Tips
Possible Causes What To Do
Oven--All Models
Ovenlight does not work Light bulb is loose or defective. Tighten or replace the bulb.
Switch operating light is broken. , Call for service.
Oven will not work Plug on range isnot completely . Hake sure electrical plug isplugged into a live,properly
inserted in the electrical outlet, grounded outlet.
A fuse in your home may Replacefuse or reset circuit breaker.
be blown or the circuit
breaker tripped.
Oven controls improperly set. Seethe Usingthe ovensection.
On self-cleaning models, door . If necessary,allow the ovento cool then unlock the door.
left in the locked position.
Food does not bake Oven controls improperly set. Seethe Usingthe oven section.
or roast properly Rack position is incorrect or the Seethe Usingthe oven section.
rack is not level.
Incorrect cookware or cookware . Seethe Usingthe ovensection.
of improper size being used.
Oven thermostat needs . See the Adjust the oven thermostat-Easy to do yourselfi
adjustment, section.
Food does not Oven is not set to BROIL. . On models with a temperature knob, make sure you turn
broil properly itall the way to the BROILposition.On models with a
BROILHI/LO pad, make sure it is turned on.
Improper rack position being used. Seethe Broiling guide.
Food being cooked in a hot pan. For best results,use a pan designed for broiling.
Hake sure it is cool.
Cookware not suited for broiling. For best results,use a pan designed for broiling.
In some areas the power . Preheatthe broil element for !0 minutes.
(voltage} may be low. . Broil for the longest period of time recommended in
the Broilingguide.
Control signals after You forgot to enter a bake , Pressthe BAKEpad and desiredtemperature or the
entering cooking time temperature or cleaning time. SELFCLEANpad and desired clean time.
or delay start
Display flashes "bAd" The installed connection . Contact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone is miswired.
Warming drawer will A fuse in your home may be Replacethe fuse or resetthe circuit breaker.
not work blown or the circuit breaker
tripped.
The oven is self-cleaning. Wait for the self-clean cycle to finish and the oven to cool.
3 2 Controls improperly set. . Seethe Usingthe warming drawer section.

Related product manuals