Excessivecondensation
in the warming drawer
GEAppliances.com
Possible Causes What To Do
Liquid in warming drawer. • Removeliquid.
Uncovered foods. • Coverfood with lid or aluminum foil.
Temperature setting too high. . Reduce temperature setting.
Food dries out in the Moisture escaping. . Cover food with lid or aluminum foil.
warming drawer
Oven temperature taa Oven thermostat . See the Adjust the oven thermostat-Easy to do
hat ar taa cold needs adjustment, yourself] section.
Clock and timer da Plug on range is not completely . Make sure electrical plug is plugged into a live,properly
nat work inserted in the electrical outlet, grounded outlet.
A fuse in your home may be • Replacefuse or reset circuit breaker.
blown or the circuit breaker
tripped.
Oven controls improperly set. . See the Using the clock and timer section.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is turned offfrom . See the Using the clock and timer section.
showing in the display.
Oven door is crooked The door is out of position. . Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the
door, push down on the high corner.
Oven makes This is the sound of the . This is normal.
clicking noise heating element turning
off and on during
cooking functions.
"F--and a number You have a function error code. . Press the CLEAR/OFF pad. Put the oven back
ar letter" flash in into operation.
the display If the function code repeats: . Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Power outage
Display flashes
Unable to get the display
ta shaw "SF"
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Pressthe
CLEAR/OFFpad. Allow the oven to cool for one hour.
Put the oven back into operation.
Power outage or surge. Some models will automatically resume their setting once
the power isrestored.On models with a clock,you must
resetthe clock. Ifthe ovenwas in use,you must reset it by
pressingthe CLEAR/OFFpad, setting the clock and
resetting any cooking function.
Power failure. . Resetthe clock.
Oven control pads were nat
pressed properly.
The BAKE and BROIL HI/LO pads must be pressed at the
same time and held for 3 seconds.
33
To Next Page
Loading...
