Installation Instructions
USE TOP CABINETTEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for tile top support screws, a
hole large enough for tile power cord to fit through,
and a cutout large enough for tile exhaust adaptor.
%
• Read tile insuuctions on tile TOP CABINET
TEMPI ,ATE.
• Tape it tmderneath tile top cabinet.
• Drill tile holes, following tile instructions on tile
TOP (;ABINET TEMPI,ATE.
CAUTION: Wear safety goggles
when drilling holes in the cabinet bottom.
CHECK FOR PROPER
DAMPER OPERATION
Damper
BlowerP_e _. ExhaustAdaptor
.... NI_Microwave
...-_ . . Oven
• Place tile microwave in its upright position, with tile
top of tile unit facing up.
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• Slide tile damper into place. Make sure it catches
in tile retaining hooks to secure.
• You will need to make adjustments to assure proper
alignment with your house exhaust duct after tile
microwave is installed.
MOUNTTHE MICROWAVE
OVEN
CAUTION: FoREnSIER
INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTAI_J_
THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use tile nylon
grommet around tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using fillet blocks if the
cabinet flont hangs below tile cabinet bottom sheh c.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When mounting
tile illiciox, vave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling
_!_ IAft tilt it
microwave,
forward, and hook
slots at back bottom
edge onto four lower
robs of mounting
_ Rotate fiont of
oven
up against cabinet
bottom.
_Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning tile screw at least two full turns after tile
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
13
To Next Page
Loading...
Need help?
General
