Full
extension
oven rocks
Oven Racks
Professional All-Gas Range
CAUTION: To ovoid possible
burns, place the racks in the correct position
before turning on the oven.
Thecorrect rack position depends on the
kind of food and the browning desired.
The racks have a frame that locks into the
rack supports on both sides. Once the frame is
locked into place, always pull the rack out, by its
upper front rail, to its full extension stop position,
when placing or removing cookware.
Remove
and
replace
oven racks
To remove a rack:
1. Hake sure the rack is pushed all the way into
the oven.
2. Graspthe rack by both its upper front rail and
its lower front rail and lift straight up to unlock
the front rack locks from the rack supports.
Lift to unlock front
rock locks from
the rock support
To replace a rack:
1.Placethe rear rack locks over and onto
the rack supports (five rack positions are
available includ ngthe top position).
Front rock lock
Upper _front
front _rail
rail
3. Firmly holding onto both the upper and lower
front rack rails, pult the rack forward and
remove it from the oven.
2. Slidethe rock all the way in until the
rear rack locks are secure on the rear rack
supports and press the front rack locks onto
the front rack supports.
Upper
front
Slide the rock alt the way in
and push down to lock the
front rack locks onto the
front rack supports
Front
rack
lock
3. Pullthe rack all the way out to check that it is
properly engaged.
Low profile
oven rack
The low profile oven rack isdesigned for
optimized performance when baking or broiling
certain foods in your Monogram ProfessionalAll-
Gas range. It can also be used as a normal oven
rack with the full extension oven racks as well.
Pleaserefer to the oven rack position table for
your bake/broil/convection mode for details asto
location and rack type for the best performance.
18
To Next Page
Loading...
