Lift-off
oven door
Care and Cleaning
Professional All-Gas Range
Thedooris very heavy.Becareful when removing
and lifting the door.
Donot lift the door by the handle.
To remove the door:
:1.Fully open the door.
2.Pullthe hinge locks down toward the door
frame, to the unlocked position. Atoot,such as
a smallflat-blade screwdriver,may be required.
3.Firmlygrasp both sides of the door at the top.
/4.Closedoor to the door removal position,
(approximately 15 degreesfrom closed) and
lift it up and out until the hinge arm is clear
of the slot.
Hinge lock
Pull hinge locks down to un]ock
Removal position
To replace the door:
1.Firmly grasp both sides of the door at the top.
2.With the door at the same angle as the
removal position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. Thenotch in the hinge arm must be fully
seated into the bottom of the slot.
5.
4,
Fully open the door. Ifthe door will not fully
open,the indentation is not seated correctlyin the
bottom edgeof the slot_
Pushthe hinge locks up against the front frame
of the oven cavity, to the locked position.
5. Close the oven door.
"_ Replacement
position
Bottom ' a'rm
edge
Indentation
Hin(
lock
Probe
Allow the temperature probe to cool before
cleaning.
The probe should be cleaned with soap and
water by hand.
Do not immerse the temperature probe in water.
Do not store the temperature probe inthe oven.
Do not clean the temperature probe in the
self-cleaning oven.
31
To Next Page
Loading...
