Care and Cleaning
Professional All-Gas Range
Spark
igniter and
electrodes
Theelectrode of the electronic ignition system is
positioned at the rear of the burner base. When
cleaning the cooktop, be careful not to snag the
igniter with your cleaning cloth. Damage to the
igniter could occur.
Be careful not to push in a control knob while
cleaning. It could cause the igniter to spark.
Hake sure that the white ceramic igniters on
the cooktop are dry and clean. Clean the metal
portion of the electrode with a soft cloth or
emery board.
Do not attempt to remove the electrode from
the cooktop.
Cleanthis metal part
with an emery board.
Do not clean this
white ceramic part
with an emery board.
Burner
grates
Theenameled cast-iron burner grates should be
cleaned regularly.
Youmust put the grates on the self-clean oven
rack during the self-clean cycle. DONOTput the
grate on the oven floor during a self-clean cycle.
DONOTput the frame inside the oven during a
self-clean cycle. Only the grate can withstand the
heat of the self-clean cycle. The frames may be
cleaned by hand or in the dishwasher.
Wash them in hot soapy water, rinse, and dry
thoroughly.
Although they are durable, the grates will
gradually losetheir shine, regardless of the
best care you can give them. This is due to their
continual exposure to high temperatures.
Do not operate a burner for an extended period
of time without cookware on the grate. Thefinish
on the grate may chip without cookwore to
absorb the heat.
Grates
Frame
Pads
Forstability, the frames have rubber pads on
each corner. During cleaning and use, be careful
not to damage or snag rubber pads.
35
To Next Page
Loading...
