CHAPTER 3: USER INTERFACES CONNECTING ENERVISTA 369 SETUP TO THE RELAY
369 MOTOR MANAGEMENT RELAY – QUICKSTART GUIDE 3–25
Z Click the Read Order Code button to connect to the 369 device and
upload the order code.
If an communications error occurs, ensure that the 369 Ethernet
communications values entered in the previous step correspond to
the relay and MultiNET setting values.
Z Click OK when the relay order code has been received.
The new device will be added to the Site List window (or Online
window) located in the top left corner of the main EnerVista 369
Setup window.
The 369 Site Device has now been configured for Ethernet communications. Proceed to
the following section to begin communications.
3.3.4 Connecting to the Relay
Now that the communications parameters have been properly configured, the user can
easily connect to the relay.
Z Expand the Site list by double clicking on the site name or clicking on
the «+» box to list the available devices for the given site (for
example, in the “Substation 1” site shown below).
Z Desired device trees can be expanded by clicking the «+» box. The
following list of headers is shown for each device:
• Device Definitions
• Settings
• Actual Values
• Commands
• Communications
To Next Page
Loading...
