To Next Page

To Previous Page

NX-4V2 Control 21

52 OPENING TIME 2.............numerical

Location 52 contains the time in 24 hour format the NX-4V2 enables codes designated as arm only after closing. This time is only valid

on those days programmed in location 54. Note: Opening time must be earlier than closing time for Auto Arm, Aux. Outputs, or Code

Authorization to function properly.

Segment 1: Program the hour of the opening time.

Segment 2: Program the minutes after the hour of the opening time.

53 CLOSING TIME/AUTOMATIC ARMING TIME 2.............numerical

Location 53 contains the time in 24 hour format the NX-4V2 disables the disarm capability for codes designated as arm only after

closing. This is also the time the Automatic Arming sequence will begin (if enabled in location 55)..

Segment 1: Program the hour of the closing / auto arm time.

Segment 2: Program the minutes after the hour of the closing / auto arm time.

54 DAYS OF WEEK SYSTEM IS OPEN 1.............feature select

Location 54 selects which days of the week the system is open. On these days, Aarm only after close window@ codes will be able to

arm and disarm during open window. NOTE: If system is not programmed to be opened and is programmed to Auto-Arm

(Location 55), the NX-4V2 will try to arm every 45 minutes for the duration of the closed period unless Auto Retry is disabled

in location 55. On days not selected here, Aarm only after close window@ codes will not disarm. (See locations 52 and 53 for the

opening and closing times for the open days.)

Segment 1:

1 = Open on Sunday.

2 = Open on Monday.

3 = Open on Tuesday.

4 = Open on Wednesday.

5 = Open on Thursday.

6 = Open on Friday.

7 = Open on Saturday.

8 = Reserved.

55 DAYS OF WEEK SYSTEM WILL AUTO ARM 1.............feature select

Location 55 selects which days the system will auto arm. If a zone is faulted when the panel tries to auto arm, the zone will be

bypassed.

Segment 1:

1 = Auto Arming on Sunday.

2 = Auto Arming on Monday.

3 = Auto Arming on Tuesday.

4 = Auto Arming on Wednesday.

5 = Auto Arming on Thursday.

6 = Auto Arming on Friday.

7 = Auto Arming on Saturday.

8 = Disable 45 minute retry timer.

GE NetworX NX-4V2 User Manual

Questions and Answers: