LOCATIONS 207-211 - RESERVED
LOCATION 212 – PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment, numerical data)
When using the XSIA dialler format, the system requires at least 1 LCD keypad. The panel will
get the zone descriptions from the first language from that LCD keypad which has the address
defined in location 212. If your system has an LCD keypad it is recommended that it will be
placed in location 1 keypad 1. This will allow location 212 to be left at the factory default. If the
LCD keypad is selected as something other than partition 1 / keypad 1, program the
appropriate address in location 212. Select the address from the location chart.
Keypad Part 1 Part 2 Part 3 Part 4 Part 5 Part 6 Part 7 Part 8
1 192 193 194 195 196 197 198 199
2 200 201 202 203 204 205 206 207
3 208 209 210 211 212 213 214 215
4 216 217 218 219 220 221 222 223
5 224 225 226 227 228 229 230 231
6 232 233 234 235 236 237 238 239
7 240 241 242 243 244 245 246 247
8 248 249 250 251 252 253 254 255
LOCATION 213 – PROGRAMMING THE COUNTRY CODE (1 segment, numerical data)
The NX-8 has the ability to set different “country codes”. Each country code has specific
default settings. Before start programming the NX-8, it is important to select the country code
that is required (see table below). Once the country code has been selected, it will remain set,
even after an installer reset. When changing the country code during programming, all
existing programming will be cleared to the defaults for that country.
Code Country
0 No country (default)
1 Holland
2 Belgium / Poland
3 Sweden
4 Italy
5 Spain
6 Greece
7 South Africa
8 Israel
9 Reserved
10 Turkey
50 US
NX-8-EUR Installation manual Page 85 02/07/06
To Next Page
Loading...
Need help?
General
