GE NetworX Series Installation And Startup Guide

NX-320E Power Supply 9
XII. PROGRAMMING
I.A. USING THE LED KEYPAD
ACTION
RESULT
1. Entering the Program Mode
  
Enters the Program Mode.
Stay, Chime, Exit, Bypass & Cancel LEDS will flash.
 Go To Program Code
Factory Default is

If the "Go To Program Code" is valid, the "Service" LED will flash and
the 5 function LEDs will illuminate steady. You are now in the
Program Mode and ready to select the module to program.
2. Entering the Module Address:
   #
(example only)
Refer to Table IX:1 on page 8 for the module address.
The Armed LED will illuminate while it is waiting for a programming
location to be entered.
3. Programming a Location:
 If an attempt is made to program an invalid entry for a particular segment, the keypad
sounder will emit a triple error beep (beep, beep, beep), and remain in that segment
awaiting a valid entry.
To Enter a Location:
 [location] #
The Armed LED will flash. If the location is valid, the "Armed" LED will
extinguish, the "Ready" LED will illuminate, and the zone LED’s will
show the data for the first segment of this location.
To Change Location Data:
 [changed data]
The "Ready" LED will flash to indicate a data change in process and
will continue until the data is saved.
 
The new data is saved.
The keypad will advance to the next segment and display its data.
NOTE: These steps are repeated until the last segment is reached.

GE NetworX Series Specifications

General

Model	NetworX Series
Zones	Varies by model (e.g., 8, 16, 32, 64)
Partitions	Varies by model (typically 1-8)
Keypads	Supports multiple keypads
Communication	Phone line, cellular, IP
Power Supply	16.5 VAC
Backup Battery	12VDC, 7AH
User Codes	Varies by model (e.g., 48, 150, 300)
Event Buffer	Varies by model (e.g., 200, 500, 1000 events)
Operating Temperature	0°C to 49°C (32°F to 120°F)
Communication Protocol	Contact ID, SIA
Weight	Varies by model
Dimensions	Varies by model (e.g., 14.5" x 12.5" x 3.5")