# "TO ACCESS MENU, ENTER [
ρ
]" - This takes you to the MENU
for the other options.
# "ZONE BYPASS ACTIVE" - One or more zones are bypassed.
Check zone status.
# “SYSTEM TROUBLE, ENTER [
ρ
] [2]” – This will identify the
service condition. Consult your security system’s user manual for
more information or call your installer.
# "POWER FAILURE" - Your system has lost electrical power.
# "LOW BATTERY" - Your backup battery has failed a system
battery test.
# "PHONE LINE TROUBLE" - Your system has detected a problem
with the phone line.
# "SYSTEM IS ARMED IN THE STAY MODE. ENTER CODE TO
DISARM. EXIT DOOR DELAY IS OFF." - Your system is
armed in the INSTANT Mode. Refer to page
6 for details.
# "WHEN FINISHED, HANG UP" - Disconnect from the
“Operator” by hanging up.
Section II. USING THE MENU
When the “Operator” is on the line, the System Status will be stated. To
access the MENU for the various features of your system, press
ρ .
The messages listed below are presented. Press the appropriate
number for the desired MENU selection.
# "FOR ZONE STATUS, ENTER [0]" - For checking open/faulted
zones. Refer to page
8.
# "TO CHANGE AREA, ENTER [1]" - For changing the area.
# “FOR SYSTEM STATUS, ENTER [2]” – For checking
armed/disarmed status of system. Refer to page
4.
# "FOR ALARM MEMORY, ENTER [3]" - For checking Alarm
Memory. Refer to page
12.
# "TO TEST SIREN, ENTER [4]" - For testing the siren.
To Next Page
Loading...
