When the “Operator” is on the line, perform the following steps to set
the TIME.
Step 1
Press ρ 9 7 .
The [ρ] accesses the MENU and [9] proceeds to the
OPTIONS menu, then [7] proceeds to the TIME section.
Step 2 “PLEASE ENTER YOUR CODE.” Enter your user code.
Step 3 “ENTER HOUR FOLLOWED BY [#].”
For example, 2 o’clock would be 2 # .
Step 4
“ENTER MINUTES FOLLOWED BY [#].”
For example, to set 18 minutes after the hour would be
1 8 #
Step 5
“ENTER [1] FOR AM. ENTER [2] FOR PM.” Press
[1] for AM or [2] for PM.
Step 6 The “Operator” will automatically return to the MENU.
Section X. ACCESSING ALARM MEMORY
While your system is in the DISARMED state, the Alarm Memory section
of the MENU is accessed with these steps:
Step 1
Press ρ 3 .
The [ρ] accesses the MENU and [3] accesses the ALARM
MEMORY.
Step 2 The “Operator” will state the name of all zones that were
bypassed or faulted during the last alarm by stating one
of the following messages:
"ALARM, ZONE 1"
"ZONE 1 BYPASSED"
"FIRE, ZONE 1"
"FIRE TROUBLE, ZONE 1"
"TAMPER, ZONE 1"
Step 3
If all zones were normal during last alarm, the
“Operator” would state the System Status.
To Next Page
Loading...
