PROGRAMMING/CHANGING ACCESS CODES
Your security system can be armed and disarmed through the
“Operator” by the Master code or the auxiliary codes. Refer to your
security system user's manual for the number of codes available in your
system. The Code Change section of the MENU is accessed in the
DISARMED state.
Step 1
Press ρ 5 .
The [ρ] accesses the MENU and [5] reaches the CHANGE
CODE instructions.
Step 2 “PLEASE ENTER YOUR CODE.” Enter your user code.
Step 3
“ENTER TWO DIGIT CODE NUMBER.” Enter the 2-
digit user code that you want to change.
Step 4
“CODE IS XXXX. ENTER NEW CODE.” Enter the new
user code.
NOTE: If the code is blank, the “Operator” will state the
code as [15] [15] [15] [15].
Step 5 “ENTER TWO DIGIT CODE NUMBER.”
Step 6 At this time, you may either enter another two-digit
code you would like to change and repeat Steps 4 – 8,
or you may exit now.
Step 7 Press # to exit or hang up.
REMOVING AUXILIARY CODES - To remove an Auxiliary user code,
use the sequence above (steps 1 – 4), and program the new code as
ρ ρ ρ ρ
To Next Page
Loading...
