GE NX-1348E-ICON - User Code Management; Adding and Changing User Codes; Deleting a User Code

NX-1348E-ICON - 12 -
g
GE Interlogix
ADDING AND CHANGING USER CODES
Your system must be Disarmed to change user codes.
Step 1 Press [r]-[5]
Step 2 The Enter Code icon will display. Enter a [“Master Arm/Disarm” Code].
N For partitioned systems, someone changing the code of another person must have access to all or more
partitions than the user being changed.
Step 3 The Ready led will flash.
Step 4 Enter the 2-digit “user number”.
(Always enter 2 digits such as [0]-[3] for user 3.)
Step 5 The instant icon will flash and zone icons will illuminate specifying the first digit of the “user code”.
 When all icons are all illuminated = code is blank; when all icons are off = “0”.
 Use the [•] and [–] keys to view the next digit or enter new 4- or 6-digit “user code”.
 While using the [•] and [–] keys, you can change any digit by entering a new digit. This will advance you to
the next digit.
To delete a user code, enter [
r
]-[
r
]-[
r
]-[
r
] for a 4-digit code, or [
r
]-[
r
]-[
r
]-[
r
]-[
r
]-[
r
] for a 6-digit code.
Step 6 The ready led will flash indicating you are back at Step 2 above. If the code is rejected, the sounder will beep 3
times.
Step 7 If another “user code” needs to be programmed, return to Step 4.
Step 8 Press the [#] key while the ready led is flashing to exit the User Code Programming Mode.