GE NX-1348E-ICON - Page 7

NX-1348E-ICON - 7 -
g
GE Interlogix
INSTANT ICON
The instant icon is “on” when there is no delay on your entry/exit door(s). Any time the instant icon is “on” and
the exit delay has expired, the opening of an entry/exit door will produce an immediate alarm. The instant icon
can be toggled on or off by pressing the [Stay] key while the system is armed. When the instant icon is “off”,
the entry/exit door(s) is delayed.
LISTEN-IN ICON
Listen-in icon is on when an NX-534 is active in listen-in mode.
POWER ICON
The power icon is on if the mains power is on. It will be off if there is no mains. The power icon will flash if the system
has a low battery condition.
READY ICON
The ready icon is “on” when the system is ready to arm and “flashes” if ready to force arm.
NOT READY ICON
The not ready icon is on when the system is not ready to arm because of a zone(s) being faulted.
ALARM ICON
The alarm icon is flashing when an alarm has occurred.
SILENCED ICON
The silenced icon appears after a code has been entered to silence the siren but the zone has not been
cleared.
TAMPER ICON
The tamper icon is on when a zone(s) is tampered. Press [
r
]–[
2
] and refer to the Service Menu section of this
manual for further instructions.
SERVICE ICON
The service icon is on when a tamper occurs or when the system requires service. Press [
r
]–[
2
] and refer to the
Service Menu section of this manual for further instructions.
TROUBLE ICON
The trouble icon is on when a dayzone(s) are faulted or when there is a trouble in the system