NX148E-CF
11
If you do not know the number of the zone you wish to bypass,
use the following steps:
Step 1 Press r • The description for zone 1 will be displayed.
Step 2 Use the • – scroll keys to browse through the custom descriptions
for the zones in this system.
Step 3 To bypass or unbypass a specific zone, press the [BYPASS] key while
that zone is displayed.
Step 4 When finished, press the # key to return to the code entry screen.
GROUP BYPASS
By pressing the [BYPASS] key, followed by the 0 key, then the [BYPASS] key
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.
UNBYPASSING
To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. NOTE: All zones will automatically be unbypassed each time
the system is disarmed.
EMERGENCY ACTIVATION KEYS
NOTE: You must press and hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activations.
Fire Key - If programmed, you can activate the Fire alarm by pressing the
Emergency Activation [Fire] key for two seconds. If your system is connected to a
monitoring center, an emergency report could be sent to that center. This key
should only be pressed in an emergency situation requiring response by fire
department personnel.
To Next Page
Loading...
Need help?
General