NX148E-CF
13
VIEW ZONE STATUS
Step 1 Press r • . The LCD Screen will display the zone status.
Step 2 Use the • – scroll keys to browse through the descriptions. The LCD
Screen will display the list of all zones in sequential order by zone number.
Step 3 Press [#] to exit this function.
SETTING THE KEYPAD TONE
Step 1 Press r 0 . Keypad is now in the “Adjust Tone” mode.
Step 2 Press • to adjust the keypad
sounder to higher tones.
Step 3 Press – to adjust the keypad
sounder to lower tones.
Step 4 When the desired tone is reached, press # to set this tone and exit from
the “Adjust Tone” mode.
VIEW ALARM MEMORY
Step 1 Press r 3 to display the zone(s) on the keypad that created the last
alarm.
Step 2 The LCD Screen will display the zone
description for those zones.
Step 3 Press [#] to exit the alarm memory.
TEST FUNCTION (Optional, if programmed)
If programmed, this function will perform a battery test, communicator test, and/or
a siren test. No alarms will be sent, and no reports will be sent unless a
communicator test is performed, in which case a test signal will be sent.
Step 1 Press r 4 4 . The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the siren.
Raise tone º
Lower tone º
Alarm Memory 1
ZONE 1
To Next Page
Loading...
Need help?
General