GE P50 Agile P253 - Page 50

5 Configuration
P50 Agile P253
5-10
P253/EN M/C
DATE AND TIME
Password protected window for “DATE AND TIME’’ settings i.e. Local
Time Enable, Local Time Offset. DST Enable, DST Offset, DST Start,
DST Start Day, DST Start Month, DST Start Mins, DST End, DST End
Day, DST End Month, DST End Mins, RP Time Zone, SET Hours, SET
Minutes, SET Seconds, SET Date, SET Month and SET Year.
CONFIGURATION
Password protected window for “CONFIGURATION’’ settings i.e.
Restore Defaults, Active Settings, Copy From, Copy To, Setting Group 1
(Enabled/Disabled), Setting Group 2 (Enabled/Disabled), System Config
(Enabled/Disabled), Overcurrent (Enabled/Disabled)
, Neg Sequence
O/C (Enabled/Disabled), Earth Fault 1 (Enabled/Disabled), Earth Fault 2
(Enabled/Disabled), Thermal Overload (Enabled/Disabled), Loss of Load
(Enabled/Disabled), CB Fail (Enabled/Disabled), Stall Detection
(Enabled/Disabled), Limit NB Starts (Enabled/Disabled), IFL, Measure’t
Setup, and Setting Values.
TRANS. RATIOS
Password protected window for
“TRANS. RATIO ’’
settings i.e Phase
CT Primary, Phase CT Sec’y, E/F CT Primary and E/F CT Secondary.
RECORD CONTROL
Password protected window for “RECORD CONTROL’’ settings i.e.
Clear Events (Yes/No), Clear Faults (Yes/No), Clear Dist Recs (Yes/No),
Clear Maint (Yes/No), Thermal Reset (Yes/No), Reset Nb Em Rst
(Yes/No), Reset Nb of St (Yes/No), Reset Motor RunT (Yes/No) and
Reset CB Data (Yes/No).
COMMUNICATION
Password protected window for
“COMMUNICATION’’
settings i.e. RP1
Address, RP1 Baud Rate, RP1 Parity and RP1 Timesync.
IO CONFIGURATION
Password protected window for “IO CONFIGURATION’’ settings i.e.
Relay, LED G, LED R, AND Logic and Opto I/P.
O/P RELAY CONFIG
Password protected window for “O/P RELAY CONFIGURATION’’
setting i.e. Contact HR/SR, O/P-1 Open Time, O/P-2 Open Time, O/P-3
Open Time, O/P-4 Open Time, O/P-5 Open Time and O/P-6 Open Time,
LED G HR/SR, LED R HR/SR, ANDEQ A Op Time, ANDEQ A Rst Time,
ANDEQ B Op Time, ANDEQ B Rst Time, ANDEQ C Op Time, ANDEQ C
Rst Time, ANDEQ D Op Time and ANDEQ D Rst Time.
DISTURBANCE REC
Password protected window for
“DISTURBANCE RECORD”
setting i.e.
Trigger Position.
COMMISSION. TEST
Password protected window for “COMMISSIONING TEST” setting i.e.
Test Mode, Test Pattern, Contact Test and Test LEDs.