– 51 –
Carefully lower the interface and disconnect the 2.
2 wire harnesses.
Remove the 4 Phillips-head screws and the 3.
cradle support from the dispenser recess.
Lift and remove the drip tray.4.
Note: There are 2 plastic wedges that help hold the
top of the trim fl ush against the door panel. If the
wedges are not installed the trim will fi t loosely.
Using a pair of long-nose pliers, pull out the 2 5.
plastic wedges.
Wire Harnesses
Wedge (1 of 2)
Note: The dispenser trim is held to the dispenser
recess by 5 retaining tabs along each side and 2 at
the top.
Using your hands or a plastic putty knife, 6.
carefully lift or pry the dispenser trim away from
the dispenser recess.
To Next Page
Loading...
Need help?
General
