– 25 –
Drum
The drum is made of 304 stainless steel and has
three replaceable baffl es.
To remove the drum:
1. Remove the top and front panels. (See Top Panel
and Front Panel.)
2. Remove the drive belt from the motor. (See Drive
Belt.)
3. Remove the Phillips-head screw from the left
side of the cabinet and gently spread the sides
apart to provide clearance for the tub.
Drum Shaft and Bearing
The drum shaft is attached to the rear of the drum
with three T-20 Torx screws. The bearing can be
removed by pulling it off the shaft. The drum shaft
and bearing fi t into the bearing retainer in the
center of the heater assembly (electric models) or
diffuser assembly (gas models).
To access the drum shaft and bearing, it is
necessary to remove the drum. (See Drum.)
Drum Shaft
Bearing
4. Using the belt as a handle, pull the drum
forward and guide out of the cabinet.
To Next Page
Loading...
