50
Service Test Mode
The washer control has a service test mode that can be utilized by the service technician
in order to test critical components and to access error codes. This test mode will help the
service technician to quickly identify failed or improper operation of washer components.
Caution: Testing is accomplished through built-in test procedures. Unplugging
components for testing can damage component connections.
The washer must be in idle mode (blue screen is blank), before entering the test mode.
Idle mode occurs when the washer has completed a cycle. If the cycle is interrupted, the
washer will drain water when the power is re-applied. The water level switch must reset
BEFORE the test mode can be entered. If water remains in the washer, manually drain
the washer to reset the water level switch. A failed water level switch can cause an
inability to enter the test mode.
CONFIDENTIAL AND PROPRIETARY INFORMATION-NOT FOR PUBLIC DISCLOSURE. September 2008
To Next Page
Loading...
Need help?
General