GE SENOGRAPHE DMR+ - Electrical Requirements; Line Voltage Specifications; Line Frequency Specifications; Kva Load Characteristics

ROOM REQUIREMENTS
GE Healthcare SENOGRAPHE DMR+
REV 1 pim 5128706–1–100
2–4
SECTION 3
ELECTRICAL REQUIREMENTS
3–1 Line voltage specifications
D Single–phase input voltage:
 5655"565"  ,'-
3–2 Line frequency specifications
D 50 or 60 Hz ('1 Hz).
3–3 kVA load characteristics
D 8.5 kVA for exposures up to 4.5 s.
7.5 kVA during 10 s.
D Power factor: 0.61.
3–4 Input impedance
Line impedance at maximum workload: 3.5%.
Line impedances under single–phase installation:

0
7 +1+0 0) *)//+3) ,+818*)- 1. +2) 3*34+9

0
6 7 0) *)//+3) ):40)+ +1 
0
9 *);43); +1 6  ,(4+ 10+<)-9
% 7 0130 (4+ 10+<)
R
l
380 = R
l
x (380/U)
2
 =(30 04)> 
0
6 v  Ω + ? $ 7 6 @
0 ONLY for GEMSE: the Generic EDM is associated with an external modem (Motorola
3265) mounted on the EDM cabinet.
For GEMS A and GEMS AM the Generic EDM incorporates a modem board inside the
EDM cabinet. 2) 1(+10 A  / /4((0); +2*14<2 +2)
B? C <+*= ,1$0 10+<) 7   C!-