GE Healthcare Senographe DS Acquisition System
Revision 1 Operator Manual 5307907-3-S-1EN
Browser
8-browser.fm Page no. 71 Chapter 8
• If the remote host cannot be reached, a pop-up message reports this fact; you should verify that
the remote host is operational and check the network cabling.
Call your network manager if the problem persists.
• If the Auto Push option is selected in Medical Application preferences, then all images in this
exam will be automatically sent to the selected destination after exam closure.
• To archive exams on the mass archiver, the archiver must be selected in the same way as a
remote host (select its icon as the drag-and-drop target, or its address as the push destination).
During a network transfer:
• To monitor network transfer tasks, click on the Network status display to open the Network queues
window, shown below:
Done
: close queue window
Click on a job to select it (hold
<Ctrl> to select more than one)
then click on
Clear to remove
job(s) from the queue
Refresh: update the queue window
(the queue window is NOT updated
automatically each time a job is fin-
ished).
Pause: temporarily halt the queue
Resume: restart a paused queue
Job currently in progress
Pause
653/1 Active
2899 Pending
273/3
Resume Clear
Pause Resume Clear
Refresh Done
Push images
Pull images
653/1 Active
2899 Pending
273/3
Network queues
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
