AUTO CHANNEL SEARCH
Now scanning channel 14
Press any key to cancel
TheVCR begins scanning for the available channels--this
takes about one to two minutes.The lowest channel is tuned
once the search is complete. Now, pressing CHANNEL up or
down should only select the active channels.
To Change the Signal Type
1. Press MENU to displaytheVCR MAIN MENU.
2. Press 4to display the CHANNELS menu.
3. Press 3 to change the SIGNALTYPE between CABLE and
ANTENNA.
To ADD or REMOVE Channels
You may want to add or remove channels after you AUTO
CHANNEL SEARCH, especially if some of the channels have weak
signals or you don't want to watch them.
.
2.
3.
Press MENU to display theVCR MAIN MENU.
Press 4 to display the CHANNELS menu.
Press 2 to display the ADD/REMOVE CHANNELS screen. Use
CHANNEL up or down or number buttons to go to the
channels you want to remove or add.
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
ADD/REMOVE CHANNELS
Channel 115
is presently REMOVED
Press INFO to add
Press MENU to exit
Selecting Channels
The CHANNEL up and down
buttons access those channels
active in yourVCR channel list.
You can still access channels not
in the channel list by using the
number buttons on the remote.
ll
To Next Page
