Things to Know Before
Components
Connecting
Protect Your Components from Power
Surges
• Connect all components before plugging any power
cords into the wall outlet.
• Always turn offtheTV and other components
before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio
Hum or Interference
• Insert all cable plugs firmly into their jacks.
Place the audio/video cables to the sides of theTV's
back panel instead of straight down the middle after
you connect your components.
• Try not to coil any twin-lead cables and keep them
away from the audio/video cables as much as
possible.
• Make sure all antennas and cables are properly
grounded. Refer to the SafetyTips sheet packed
with your unit.
6
V
V
V
V
CONNECTIONS
V
Protect Your Components from
Overheating
• Do not block ventilation holes in any of the
components. Arrange the components so that air
can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier or satellite receiver on the top
shelf of the stand so heated air rising from it will
not flow around other components.
37
To Next Page
