Back Panel
AUDIO VIDEO
OUTO --
,N10 --O
IN FROM O
ANT.
VHF/UHF
OUT TO TV
3CH. 4
rl_
3 CH. 4 Switch Selects the channel to which you will tune theTV to see the VCR
picture if you connect the VCR using one of the basic hookups.
AUDIO and VIDEO IN Jacks Receives signals from another component, like a VCR
or camcorder, when it is connected to these jacks. Use INPUT on the remote to select
these jacks.
AUDIO and VIDEO OUT Jacks Sends signals fromVCR to another component,
like aTV or VCR, when it is connected to these jacks.
IN FROM ANT. Jack Receives a signal from an antenna or cable system when
attached.
OUTTOTV Jack Passes signal toTV using the cable supplied.
Indicator Panel
0 POWER r_ VCR O TIMER • RECORD
POWER Indicator Lights when theVCR is turned on.
RECORD Indicator Lights when theVCR is recording.
TIMER Indicator Lights during an express or timer recording, or when theVCR is
set for a timer recording and the VCR is turned off. Flashes when the clock is not
set.
Flashes when a timer recording is set and there is no cassette in theVCR, and when
the VCR's clock is not set.
VCR Indicator (Applies Only if the VCR Viewing Channel is 3
or 4). Press theTVeVCR button to turn on or off.
• VCR indicator on: Picture from VCR.
• VCR indicator off: Picture fromTV channel.
45
To Next Page
