VCR makes noise when stopped
• VCR is removing tape from heads.This is normal. The head cylinder inside the VCR will continue to rotate for a few
minutes after you put the VCR in the stop mode.
Will not AUTO CHANNEL SEARCH active channels correctly
• Check to make sure the antenna connections are secure and correct.
• Check to make sure the SIGNALTYPE: CABLE/ANTENNA feature is set correctly.
• If DETECT AUTOMATICALLY was selected for the SIGNALTYPE in the AUTO CHANNEL SEARCH menu, select either
CABLE TV or ANTENNA.
Tape plays back in slow motion
• Press PLAY to return to normal playback.
Cannot select channels over 69
• Cable channels over 69 can only be selected if SIGNALTYPE: CABLE/ANTENNA feature is set to CABLE.
Cassette with safety tab removed does not start to play automatically
• Check to make sure the AUTO PLAY ON/OFF feature is set to ON.
TIMER indicator flashes
• Clock is not set.
• Check to make sure there is a cassette in the VCR when a timer recording is set.
Time counter disappears during searching
• This is normal.
On-screen menus appear in an incorrect language
• Use the Language feature to change the on-screen display language.
48
To Next Page
