Step 1: Unpack what's in the box
The following items come packed in the box:
• VCR
• Remote control
• RF coaxial cable
STEP 2: Install batteries in the
remote control
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1. Remove the cover of the battery compartment.
2. Place the batteries in the remote, matching the + and - ends
of each battery to the diagram inside the compartment.
3. Replace the cover.
STEP 3: Connect your VCR
If you connect your VCR to your home antenna or cable system
and then to yourTV, use the VCR's ANT. IN and RF OUTjacks for
a good signal as shown.
If you have a TV with AUDIO/VIDEO jacks, use the jacks for a
better connection. Refer to the Connections section, toward the
back of the manual.
VCR
TV
CABLE, CABLE BOX, OR_'_I_ANTENNA
I
CABLE/ I
__NNA
4
To Next Page
Loading...
