5. Enter the data for the program with the number buttons.
The data includes the channel number (press INPUT to select
the line input), start time including AM or PM, and end time. The
start date is automatically entered based on the VCR clock. The
date and/or speed can be changed when flashing.
6. Review the information to make sure it is correct, and then
press MENU to save.
Program 1 (One Time)
Channel 03 Cable
Start Time 08:00 PM
End Time 09:30 PM
Start Date 11/28/97 TUES
Tape Speed SLP
I=SP 2=SLP
Press CLEAR to correct
Press MENU to save
Program 1 has been saved
Remember to insert a
recordable tape and
turn the VCR off before
the program start time.
Press MENU to continue
Timer Recording with VCR Plus +
You can useVCR Plus+ to simplify timer programming if you
have cableTV and don't receive all channels through a cable
box or if you receive yourTV signal off-air.
Setting Up the Channel List
If you did not set up theVCR Plus+ channel list, you can do it now.
1. Display the CHANNELS menu from the VCR MAIN MENU.
2. Display the VCR Plus+ Channel List menu.
3. Go to Setting Up Your VCR if you need more information on
setting up your VCR Plus+ channel list.
Using VCR Plus+
1. Press MENU to bring up the VCR MAIN MENU.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Preferences
6 Language
0 Exit
VCR MAIN MENU
VCR Plus+
Timer Recordings
Time
Channels
CHANNELS
1 Auto Channel Search I
I
2 Add/Remove Channels I
I
3 Signal Type: CABLE
4 VCR P us+ Channe L st
VCR+ Channel My Channel
5 46
4 --
3 -> -> -> 23
2 --
1 --
Use CH+/- to select
Press 0-9 to change
Press MENU to save
24
VCR Plus+ and PlusCode are registered
trademarks of Gemstar Development Corporation.
To Next Page
Loading...
