Geberit HS30 - Page 24

EN
24
9007210246122763 © 05-2023
971.552.00.0(01)
Repair
Backwards compatibility of the control unit
The control units for Geberit hygiene flush units are backwards-compatible as follows:
Defective control unit Suitable control unit as a spare part
²
HS50
²
Art. no. 245.595.00.1
• Operation with Geberit Control app
• Interfaces are compatible
HS30
Art. no. 245.594.00.1
• Operation with Geberit Control app
• Digital I/O interface is compatible
²
With use of the interfaces (RS485,
Digital I/O) or sensors
²
Art. no. 243.069.00.1
• Operation with Geberit SetApp
• Interfaces are compatible
Without use of the interfaces
²
Art. no. 245.594.00.1
• Operation with Geberit Control app
²
With use of the interfaces (RS485,
Digital I/O)
²
Art. no. 243.069.00.1
• Operation with Geberit SetApp
• Interfaces are not compatible
Without use of the interfaces
²
Art. no. 245.594.00.1
• Operation with Geberit Control app
The following must be observed when replacing the control unit:
• Flushing programmes and flush logs cannot be transferred from one control unit to another. The flushing
programmes must be transferred manually.
• If possible, read out the flushing programmes and export the flush logs before replacing the control unit:
– Control units with year of manufacture from 2023: with the Geberit Control app
– Control units with year of manufacture 2015–2023: with the Geberit SetApp
– Control units with year of manufacture up to 2014: with the Geberit Service Handy or by reading
parameters on the display or on the inside of the cover plate