GH20SB – User Manual PAGE 11
PPUH “GECO” Sp. z o.o. FROM 05/01/2015
To set the time zones for the device marked with “K” on the scheme follow the same
procedure as when selecting working hours for circulation pump C.
3.3.4.4. Editing Heating Medium Freezing Point
To edit heating medium freezing point choose “Parameters settings” on the main menu
screen and then “Heat transfer fluid” on the settings configuration menu screen.
When you go to this screen the setting value flashes. Press and to define a new
heating medium freezing point temperature in the range from -35 to 0ºC.
Press to save the new value and return to the settings configuration menu.
Press to cancel changes and return to the settings configuration menu.
Press to cancel changes and cause the Controller to switch to the standby mode.
3.3.4.5. Editing Rated and Minimum Flow
To edit rated and minimum flow choose “Parameters settings” on the main menu screen and
then “Flow rate” on the settings configuration menu screen.
To Next Page
Loading...
Need help?
General
