104
road conditions. The driver should is fully
responsible for safe driving.
Function selection
On the multimedia display screen, click Set
up → Auxiliary Driving → CCM in turn, and
enable/disable the intelligent navigation
function in this interface.
Function activation
The ICC control button is located on the left
side of the steering wheel.
1. ICC button
Press and release this button to start,
stop and exit the ICC system.
2. Inter-vehicle interval increasing button
Press and release this button to
increase the following interval of the
ICC system.
3. Speed adjustment and setting button
• Push the button up
Push and release: cruise speed
+1km/h or resume the cruise speed
originally set by the driver.
Push and hold: cruise speed +5km/h.
• Push the button down
Push and release: cruise speed -1
km/h.
Push and hold: cruise speed -5km/h.
4. Inter-vehicle interval decreasing button
Press and release this button to
decrease the following interval of the
ICC system.
Activate the ICC system, the following
conditions must be met:
• Press the ICC button to enable the ICC
system.
• The gear is in the drive gear (D).
• The ready for operation indicator on the
instrument cluster is on.
• The four doors, trunk and front
compartment hood are all closed.
• The vehicle is in motion, and the brake
pedal is not applied.
• No fault on brake disc.
• The front camera has no problems such
as high temperature, dirt or failure.
• The ESC system is on.
• EPB is released.
• The driver fastens the seat belt.
1. When the vehicle is stationary, activate
the ICC system as follows:
Starting and driving
To Next Page
Loading...
Need help?
General
