2
8
7
6
5
4
3
1
19
Start button
Power supply mode
The vehicle is equipped with an inductive
starting system without a starting switch. To
start the vehicle, the smart key matching the
vehicle must be in the vehicle and detected.
Vehicle power statuses can be divided into
as follows:
ACC: use a smart key to unlock and open
the driver’s side door. If there is no other
person at the driver’s side, the power
supply of the vehicle will be switched to
ACC gear. At the same time, the vehicle will
enter into Non-ready Mode at the high
voltage. Then, partial functions of the
vehicle are available, such as the
infotainment system.
ON: the driver gets on the vehicle, and when
he recognizes the legal key in the vehicle
and steps down the brake pedal to shift the
gear to the drive (D) or reverse (R) gear, the
power supply of the whole vehicle is
switched to the ON gear, the high voltage
enters READY, and the vehicle can be
driven normally.
OFF: After parking, the driver gets off. All
doors are closed. Use remote control or
polling to lock. The vehicle is powered down
and shifted to OFF gear.
Power down in emergency
When the vehicle is abnormal and cannot
be powered down by opening and closing
the door, the following methods can be used
for emergency power-down:
First, make sure the vehicle is stationary,
then depress the brake pedal and press and
hold the hazard warning lamp switch for
more than 7 seconds to power down to
OFF.
Entering and leaving
To Next Page
Loading...
Need help?
General
