120
front camera above the windshield, the
system automatically toggles between high
beam and low beam according to the light of
vehicles in the same or opposite direction,
as well as the ambient light. Generally, this
function automatically toggles the high
beam to low beam when the headlamps of
the oncoming vehicle, the taillights of the
forward preceding vehicle or other light
sources are detected to avoid the glare of
high beam to surrounding traffic
participants. After the vehicles meet,
overtake or there is no ambient light source
around, the low beam is automatically
toggled to high beam.
Function enabling/activation
On the multimedia display screen, click Set
up → Auxiliary Driving → Intelligent high
beam control in turn. In this interface, select
to enable or disable the intelligent high
beam function.
Turn the light control combination switch to
AUTO.
At night, after the front combination lamps
automatically turn on, IHBC system is
activated automatically.
After the IHBC system is activated, the
IHBC system will recommend to turn on the
high beam if all the following conditions are
met:
1. Vehicle speed ≥ 40 km/h;
2. No relevant traffic participants or other
light sources were detected.
The IHBC system will recommend to turn on
the low beam when any of the following
conditions are met:
1. Vehicle speed≤ 25 km/h;
2. Relevant traffic participants or other light
sources are detected.
When IHBC system has
recommended to turn on the high
beam, and the vehicle speed maintains in
25~40 km/h, the IHBC system can still
remain the high beam until the light source
information is detected and IHBC will
recommend to turn on the low beam.
Starting and driving
To Next Page
Loading...
Need help?
General
